WD 4TB - это USB, подключенный к RPi2B. Ценю твою помощь.
# uname -r
4.14.69-v7+
HDparm отображает 4000 ГБ, но ядро, вероятно, не для gdisk, а fdisk тоже.
/var/log/syslog:
Sep 13 20:00:09 petaf kernel: [19193.944765] usb 1-1.5: new high-speed USB device number 13 using dwc_otg
Sep 13 20:00:09 petaf kernel: [19194.076119] usb 1-1.5: New USB device found, idVendor=1058, idProduct=1021
Sep 13 20:00:09 petaf kernel: [19194.076140] usb 1-1.5: New USB device strings: Mfr=1, Product=2, SerialNumber=3
Sep 13 20:00:09 petaf kernel: [19194.076151] usb 1-1.5: Product: Ext HDD 1021
Sep 13 20:00:09 petaf kernel: [19194.076164] usb 1-1.5: Manufacturer: Western Digital
Sep 13 20:00:09 petaf kernel: [19194.076175] usb 1-1.5: SerialNumber: 574343374B3553584B444650
Sep 13 20:00:09 petaf kernel: [19194.077242] usb-storage 1-1.5:1.0: USB Mass Storage device detected
Sep 13 20:00:09 petaf kernel: [19194.085826] scsi host1: usb-storage 1-1.5:1.0
Sep 13 20:00:09 petaf mtp-probe: checking bus 1, device 13: "/sys/devices/platform/soc/3f980000.usb/usb1/1-1/1-1.5"
Sep 13 20:00:09 petaf mtp-probe: bus: 1, device: 13 was not an MTP device
Sep 13 20:00:10 petaf kernel: [19195.156098] scsi 1:0:0:0: Direct-Access WD Ext HDD 1021 2002 PQ: 0 ANSI: 4
Sep 13 20:00:10 petaf kernel: [19195.157493] sd 1:0:0:0: Attached scsi generic sg1 type 0
Sep 13 20:00:10 petaf kernel: [19195.158559] sd 1:0:0:0: [sdb] 4294961152 512-byte logical blocks: **(2.20 TB/2.00 TiB)**
Sep 13 20:00:10 petaf kernel: [19195.159885] sd 1:0:0:0: [sdb] Test WP failed, assume Write Enabled
Sep 13 20:00:10 petaf kernel: [19195.160909] sd 1:0:0:0: [sdb] Asking for cache data failed
Sep 13 20:00:10 petaf kernel: [19195.160926] sd 1:0:0:0: [sdb] Assuming drive cache: write through
Sep 13 20:00:10 petaf kernel: [19195.189942] sd 1:0:0:0: [sdb] Attached SCSI disk
Sep 13 20:00:10 petaf systemd-udevd[2880]: Process '/lib/udev/hdparm' failed with exit code 5.
# hdparm -I /dev/sdc
/dev/sdc:
ATA device, with non-removable media
Model Number: WDC WD40EZRZ-00GXCB0
Serial Number: WD-WCC7K5SXKDFP
Firmware Revision: 80.00A80
Transport: Serial, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0
Standards:
Used: unknown (minor revision code 0x006d)
...
...
LBA user addressable sectors: 268435455
LBA48 user addressable sectors: 7814037168
Logical Sector size: 512 bytes
Physical Sector size: 4096 bytes
Logical Sector-0 offset: 0 bytes
device size with M = 1024*1024: **3815447** MBytes
device size with M = 1000*1000: **4000787** MBytes (**4000** GB)
# fdisk -l /dev/sdc
Disk /dev/sdc: 2 TiB, 2199020109824 bytes, 4294961152 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
cache/buffer size = unknown
Я испытываю это как на моем RPi2B, так и на моих хостах Mint. Оба запускают ядро 4.+ и поддерживают 'GPT' и 'Advanced Partition'.
# egrep '^[^#].*(EFI_PAR|TION_ADVANCED)' config
CONFIG_PARTITION_ADVANCED=y
CONFIG_EFI_PARTITION=y